Electrician Charges in Delhi NCR (2026): Job-by-Job Rate List

Electrician rate list for Delhi NCR (labour charges, 2026)

These are the ranges independent electricians across Delhi NCR generally quote in 2026. They are labour. The fan, the switch, the MCB, the wire — those are materials, and they are almost always billed on top or bought by you (more on that below).

Indicative Delhi NCR market ranges, 2026. Each professional sets their own charge and quotes you free before starting. Parts are normally billed on top of labour.

The visiting charge — and whether it comes off the final bill

This is the part almost nobody explains, and it is where most of the arguments start.

Many electricians charge a visiting or inspection charge — a fee simply for coming to your home, looking at the problem and telling you what it will cost. It is not a scam. A trip across Delhi in traffic can eat 90 minutes each way, and an electrician who gives that away for free is subsidising every enquiry that never converts.

The question you must ask, before they set out, is this one:

"Is the visiting charge adjusted against the final bill if I go ahead with the work?"

There are three answers you will hear, and all three are legitimate — as long as you hear one of them before the person arrives, not after:

The failure mode is not a high fee. It is a fee nobody mentioned. Settle it on the phone: what is the visiting charge, and is it adjusted if I go ahead? An honest professional will answer in one sentence. And if they have come out, opened the board and diagnosed the fault, and you then take that diagnosis to someone cheaper — pay the visit charge. You used their labour.

Labour vs materials — what you buy, what they charge

Nearly every quote confusion in electrical work comes down to this one distinction. The ranges in the table above are labour only.

• You usually supply the item. The fan, the geyser, the light fitting, the CCTV camera, the inverter, the modular switch plate — most Delhi households buy these themselves, from a shop or online. The electrician charges to fit them.
• They usually supply the consumables. Wire, tape, screws, conduit, wall plugs, connectors. Small stuff, and it is normal for it to be folded into the labour or added as a small line.
• The grey zone is the mid-priced part. An MCB, a socket, a switchboard plate, a length of wire — the electrician can fetch it, and often will. Agree the price before they do, and ask for the shop bill. A professional hands it over without being asked twice.
• Never accept a single lump sum for a job with parts in it. "₹1,500 for the whole thing" tells you nothing. Ask for it split — labour ₹X, parts ₹Y — and now you can compare quotes and see any markup.
• Do not cheap out on the part that carries current. Switches and fittings are cosmetic; MCBs and wire are safety devices. A no-brand MCB that does not trip when it should is not a saving.

What makes a quote go up (and why it can still be fair)

Two flats in the same block can be quoted very differently for what sounds like the same job. Here is what actually moves the number.

• Concealed vs surface wiring. The single biggest multiplier. A new point in surface conduit is quick. Running it concealed means chasing a channel into the wall, laying conduit, pulling wire, then filling and finishing the wall — which is why concealed wiring is charged per point (₹300–500 above). Same name, different job.
• Old aluminium wiring. Many older DDA flats, government colonies and pre-2000 builds in Delhi were wired in aluminium — soft, prone to creeping loose under a screw terminal, and brittle after decades of Delhi heat. An electrician who opens a board, finds crumbling aluminium and says the joint cannot simply be re-tightened is not padding the bill. Expect a higher quote, and a conversation about the whole circuit rather than the one socket.
• Height and access. High ceilings, stairwell fittings, an outdoor camera on the third floor — a ladder and often a second person. Fair for that to cost more.
• How buried the fault is. "The socket is dead" can be a loose wire behind the plate (ten minutes) or a break in a concealed run (an afternoon and a broken wall). Nobody can tell which over the phone, and anyone promising a firm price unseen is guessing.
• Night and Sunday work. Most electricians add a surcharge outside normal hours, on a Sunday, and for a genuine emergency call-out. That is standard across NCR — it is the price of someone leaving their family at 10pm. Ask what it is when you book, not when you pay.
• Volume. Five points quoted together almost always beat five points quoted one at a time. If you have a list, give the whole list.

How to sanity-check an electrician's quote

You do not need to know electrical work to spot a bad quote. You need six questions.

• "Is this labour only, or does it include parts?" If they cannot separate the two on the spot, that tells you how the bill will grow.
• "Is the visiting charge adjusted if I go ahead?" Ask before they leave their house, not after they reach yours.
• "Per point or per room?" New wiring is priced per point across NCR. A quote "per room" cannot be benchmarked against anything — which is often the point of it.
• "Can I keep the old part?" The burnt MCB, the dead switch, the failed socket. It costs an honest professional nothing, and it quietly ends the "I replaced it, trust me" problem.
• "What happens if it trips again next week?" Someone who found the fault answers comfortably. Someone who swapped a part and hoped does not.
• Get a second quote on anything above ₹5,000. On a full 2BHK rewire (₹25,000–55,000 in labour), a second opinion is worth an afternoon of your time.

And one thing that is not about money at all: if an electrician tells you the wiring is unsafe, take it seriously enough to get a second opinion — not seriously enough to ignore. Scorch marks, a burning-plastic smell, warm switchplates and repeated tripping are not cosmetic complaints. If any of those are present, stop using the circuit until someone competent has looked at it.

Two follow-ons worth reading before you spend anything. If the problem is a breaker cutting out, do not simply pay to have it swapped — a healthy MCB that trips is doing its job. Start with why your MCB keeps tripping in Delhi. And if you are seeing scorch marks or smelling hot plastic, read the signs your house wiring needs replacing — that is a different, and more urgent, conversation.